Compton, Alfred G. (Alfred George), 1835-1913 · New York : J. Wiley & Sons · leaf 132
118 FIBST LESSON'S IN METAL- WOBKING. chisel at one end of the line drawn on the face, and, holding it horizontally, strike it a vigorous blow, cutting off a triangular chip, and making a chamfer or bevel, as shown by the dotted line in Fig. 63. Extend this along the whole length of the end of the… … Fig. 63. Now, using the cape-chisel, set it on the bev- elled surface, at the end of one of the proposed grooves, and with the edge about below the upper surface, as in Fig. 64. Incline the handle upwards, so that the lower cutting-face shall make a very small angle, abdy with the intended direc-…
Metal-work
Internet Archive · Getty Research Institute · Public domain (published before 1931). Free to use for anything.
